FOR "JACK JONES" ONLY!!!! Series L/R and RC Circuits

profiledzaiki
  1. Watch the video
    • Week 6 Video Lecture – Multisim Series RL
  2. Construct the series L/R and RC circuits from this week’s assignment in MultiSIM and perform Transient Analysis on each circuit to confirm your calculations. Use a 5% tolerance for all of the components. Capture a screenshot of the output of the analysis to confirm your calculations. Create a table to demonstrate your expected and measured values.
  3. Include a discussion of the following:
    1. Differences between the calculations and the simulations.
    2. How would you go about designing a circuit with an applied voltage of 24V and a resistor of 1kohms such that the current in the circuit starts out at 0A and reaches 24mA in 2 seconds?
    3. How would you go about designing a circuit with an applied voltage of 24V and a resistor of 1kohms such that voltage starts out at 0V and reaches 24V in 2 seconds?
  • 8 years ago
  • 30
Answer(1)

Purchase the answer to view it

blurred-text
  • attachment
    lab_transient_analysis.docx