complete test

True

False

3 points

QUESTION 2

Doping is a process of adding impurity atoms to an intrinsic crystal to alter its electrical conductivity.

True

False

3 points

QUESTION 3

You can quickly check the condition of a diode with an ohmmeter on a high resistance range.

True

False

3 points

QUESTION 4

The letter Q is an abbreviation for quiescent, which represents the AC signal is operating between cut-off and saturation points of the transistor.

True

False

3 points

QUESTION 5

The half-wave rectifier has a diode in parallel with a load resistor.

True

False

3 points Save Answer

QUESTION 6

In an NPN transistor, the emitter and collector are both n-type materials.

True

False

3 points

QUESTION 7

The dc beta is also known as the current gain because a small base current controls a much larger collector current.

True

False

3 points

QUESTION 8

The load line is a visual summary of all the possible transistor operating points.

True

False

3 points

QUESTION 9

With the switch in the position as shown in Figure 1 below, the LED is on.

figure 1

True or False

QUESTION 10

A transistor can be tested using an ohmmeter to check back and front resistances of emitter-base, collector-base, and collector-emitter.

True

False

3 points

QUESTION 11

Hard saturation refers to any design that makes the saturation current gain approximately:

1

10

100

1000

4 points Save Answer

QUESTION 12

While testing a transistor with an ohmmeter, a high reverse/forward resistance ratio for the emitter-base and base-collector junctions indicates

this transistor is good.

this transistor is open and should be replaced.

this transistor is shorted and should be replaced.

this transistor is a small-signal amplifier.

4 points Save Answer

QUESTION 13

A major advantage of an optocoupler is the:

electrical isolation between input and output circuits.

electrical connection between input and output circuits.

higher gain.

low cost of manufacturing the device.

QUESTION 14

With normal circuit operation, Vout in Figure 2 is ________.

figure 2

Approximately 0V

115 Vac

20 V

10 V DC

4 points Save Answer

QUESTION 15

If the 115 V ac is removed from the circuit shown in Figure 2, what would be measured at Vout?

figure 2

approximately 0 V

115 V

20 V

10 V

4 points

QUESTION 16

What type transistor connection is shown in Figure 3 below?

Figure 3

common emitter

common collector

common base

emitter follower

QUESTION 17

What is the device that increases a transistor's power rating by reducing the internal heat faster?

heater wire

chassis

grommet

heat sink

4 points Save Answer

QUESTION 18

Another name for diode offset voltage is:

barrier potential

ripple voltage

surge voltage

filtered voltage

4 points Save Answer

QUESTION 19

The second approximation of a silicon diode is basically the:

the diode appears as a switch in series with a barrier potential of 0.7 V

the diode appears as a switch in parallel with a barrier potential of 0.7 V

the diode appears as a barrier potential of 0.4 V

the diode appears as a short circuit

4 points Save Answer

QUESTION 20

What is the most popular and useful semiconductor material?

Silver

Copper

Aluminum

Silicon

4 points Save Answer

QUESTION 21

Refer to Figure 4 below.

Figure 4

What is the Peak secondary voltage?

What is the peak-to-peak voltage at the filter point considering non-ideal diode?

Attach file

15 points Save Answer

QUESTION 22

For the CE circuit shown in Figure 5 below, draw the dc load line and mark the dc working point on it. Assume Beta=100 and neglect VBE.

Figure 5

Attach File