LabVIEW Assignment

California State University, Fullerton College of Engineering and Computer Science

EGGN 100 Introduction to Engineering Fall 2015

LabVIEW Assignment

Demo Due Today (in class)

Report Due at the beginning of class on September 10, 2015 (Thursday)

In this assignment, you need to do the following:

1. Using LabVIEW, generate and display a square wave

2. Modify the program from step 1 and add a ‘knob’ to control the amplitude of the square wave that

you generated in step 1 above. Verify that the amplitude of the square wave changes when you

turn the ‘knob’. Save two copies your program with filenames as Square.vi and HiSquare.vi

3. Now, modify the program in HiSquare.vi to scale (i.e. multiply) the amplitude of the square

wave by 10 using a ‘Formula’ VI. Verify the results and save the program file.

(You must complete steps 1, 2 and 3 in 30 minutes)

4. Demonstrate the results corresponding to part 2 (Square.vi ) and part 3 (HiSquare.vi) to the

instructor before the end of class today

5. Turn in a 1-page hard-copy report at the beginning of class on September 10, 2015 (Thursday).

Use Times New Roman font; size 11; 1.5 line spacing to type your report. Your report should

include descriptions for the following:

• The goal(s) of the assignment • The procedure that you followed in order to complete the assignment • Challenges/difficulties faced (if any) and how you overcame them • What you were able to accomplish at the end? • Conclusion