Week 8
gerott
week_8.docxHW8 Fourier Circuit Analysis
1. Read Chapter 18 in Engineering Circuit Analysis 8th Edition.
2. Work Chapter 18 Practice Problems 18.1, 18.2, and 18.14.
3. Enter all work in the HW8 Assignment drop box. Show all work for full credit.
LAB8 Capacitors and Inductors
1. Watch video entitled “Module 8 – Steady-State RL Circuit in MultiSIM”.
2. Construct Figure 18.15, pg. 774 and capture screenshots similar to Figure 18.16-18.17.
3. Include MultiSIM screenshots in a document entitled “Simulation8_StudentID”.
4. Upload file “Simulation8_StudentID”.
Final
For the circuit below, perform the following:
1. Given an AC input voltage of Vrms = 200Vrms and a sinusoidal frequency of omega = 120pi rad/sec, determine the following:
· V1peak (peak value of AC input voltage)
· V1(peak-to-Vpeak )(peak to peak value of AC input voltage)
· Frequency of input voltage V1 in Hz.
· V2peak (peak value of AC output voltage)
· V2(peak-to-Vpeak )(peak to peak value of AC output voltage)
· Frequency of output voltage V2 in Hz.
2. Construct circuit in MultiSIM using calculated values for V1.
3. Capture a screenshot that shows V1 and V2 on an oscilloscope XSC1.
4. Submit calculations, MultSIM screenshot and MultiSIM circuit (.ms11) file.
For the circuit below, perform the following:
5. Given a voltage gain of -10, determine the value of R2.
6. Calculate the peak-to-peak value of Vout and rms value of Vout.
7. Construct circuit in MultiSIM with calculated value of R2.
8. Capture a screenshot that shows the input voltage V1 and output voltage Vout in MultiSIM with an oscilloscope XSC1
9. Submit calculations, MultSIM screenshot and MultiSIM circuit (.ms11) file.
