The subnet mask selected:
In this example, when host 172.16.0.0 at Site A accesses the same IP-addressed host at Site B, it connects to a 172.19.0.2 address rather than to the actual 172.16.0.3 address. When the host at Site B to accesses Site A, it connects to a 172.18.1.2 address. NAT on Router A translates any 172.16.0.4 address to look like the matching 172.18.0.5 host entry. NAT on Router B changes 172.16.x.x to look like 172.19.x.x.
The maximum number of subnets provided by the selected subnet mask:
These are 10.
The maximum number of hosts allowed for each subnet:
Host allowed 2.
STEP 2:
![]()
STEP 3:
The two primary categories o routing protocols are interior gateway protocols and exterior gateway protocols. Typically, interior gateway protocols (IGPs) are used within an organization or a single auto nous system (AS) and exterior gateway protocols (EGPs) are used between multiple autonomous systems. IGPs for transmission Control Protocol/Internet Protocol (TCP/IP) include the Routing Information Protocol (RIP), the interior gateway routing protocol IGRP).
Interior routing protocols are the mainstay for many CCIEs in the field. It is imperative that a CCIE candidate understand the theory behind these protocols and know how to configure each of them. Static versus dynamic routing, interior versus exterior routing protocols, and distance vector versus link-state routing protocols.
STEP5
System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
Copyright (c) 2000 by cisco Systems, Inc.
Cisco 2621 (MPC860) processor (revision 0x200) with 253952K/8192K bytes of memory
Self decompressing the image :
######################### [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-I-M), Version 12.2(28), RELEASE SOFTWARE (fc5)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 27-Apr-04 19:01 by miwang
Cisco 2621 (MPC860) processor (revision 0x200) with 253952K/8192K bytes of memory
.
Processor board ID JAD05190MTZ (4292891495)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
63488K bytes of ATA CompactFlash (Read/Write)
Press RETURN to get started!
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to administratively down
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to administratively down
%SYS-5-CONFIG_I: Configured from console by console
Router>enable
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Router(config)#hostname 172.16.0.0
172.16.0.0(config)#
172.16.0.0(config)#end
172.16.0.0#copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
172.16.0.0#
%SYS-5-CONFIG_I: Configured from console by console
172.16.0.0#copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
[OK]
172.16.0.0#
172.16.0.0#
172.16.0.0#
STEP6
By using this method I have divided the networking into 5 different assigned ips using routers and hubs.
sarees
network_project_ethar.docx
0
