This procedure will only need to be performed one time to properly initialize your environment. The following steps must be performed in sequence to ensure proper configuration and successful execution of future labs.
1. Log into the Citrix environment using your Citrix credentials. If you have difficulty with your password, please call the Help Desk at 877-784-1997. There is also Citrix-specific help information and tutorials in your Course Home iLab section.
2. Start Windows Explorer from the application list on Citrix. Your window will appear similar to the one shown below (Note: the number of drives shown will depend on the configuration of your computer). At a minimum though, everyone will have a personal F: drive and will have access to a shared read-only G: drive.
![]()
3. In Windows Explorer, ensure that the directory, F:\op_models, exists. If it does not exist, create it.
4. Copy the G:\OPNET\SEC450 directory to your F:\op_models directory.
5. Once the SEC450 directory has been copied to F:\op_models, you’ll need to copy two files (SecurityZones.gdf and selfdesc.sddb) from the SEC450 directory to your op_models directory as shown below.
![]()
6. At this point, your environment is properly initialized and configured for the SEC450 iLabs.
909kidd
documents--sec450_opnet_ilab_preparation.docx
0
