modificationsNIII

note that I forgot to provide to you a data from our lab and it's in attachment. it wil provide to you the length data please change the following: 1- for part b change the lbs to N for force so the torsion and bending data would changed.Also, you need to change the plots. 2- for part c each plot should has 3 lines, please read the question carefully. 3- for part d you need to have only Exy with 3 different lengths 4- for part e you need to put unit in table as well as for each plot should has 3 lines 5- for part f you need to have two lines one for experimental, other one for theoretical 6- same: for part g you need to have two lines one for experimental, other one for theoretical 7- for part h you need to write more. 8- for all plots you need to write what the plot shows and this instruction from professor:Please remember that the results and discussion section of the lab reports must include a discussion of your results. Every table and plot that is listed in the handout must be discussed to earn the points that are associated to it. The best way to do this is to provide a discussion shortly after the table or plot is presented, so the report reads as what it should be: a technical report meant to be read by somebody with technical knowledge. Please refrain from using contractions and informal phrases, since those are not appropriate for technical reports. In addition, when making comparisons BE QUANTITATIVE! Do not say this is larger or smaller, say this is larger by x% or smaller by y%. Engineering is about quantification! 9- the data would be affected so change the necessary for abstract,objective and conclusion 10- remove the equations from abstract