Liberty University
CSIS331
Lab 3 Answer Sheet
Submit this completed document with your completed and saved packet tracer in the link provided in
Blackboard.
Part 1: Questions.
Step 1:
a. Which command displays the statistics for all interfaces configured on a router?
Show interfaces
b. Which command displays the information about the Serial 0/0/0 interface only?
Show interface serial 0/0/0
c. 1) What is the IP address configured on R1?
Internet address is 209.165.200.225/30
c. 2) What is the bandwidth on the Serial 0/0/0 interface?
BW 1544 Kbit
d. 1) What is the IP address on R1?
No IP address configured
d. 2) What is the MAC address of the GigabitEthernet 0/0 interface?
address is 000d.bd6c.7d01
d. 3) What is the bandwidth on the GigabitEthernet 0/0 interface?
BW 1000000 Kbit
Step 2. Questions.
a. Which command displays a brief summary of the current interfaces, statuses, and IP addresses
assigned to them?
Show ip interface brief
b. 1) How many serial interfaces are there on R1 and R2?
4 serial interfaces
b. 2) How many Ethernet interfaces are there on R1 and R2?
6 Ethernet interfaces on R1 2 Ethernet interfaces on R2
b. 3) Are all the Ethernet interfaces on R1 the same? If no, explain the difference(s).
2 gigabit and 4 fast ethernet gigabits support 1 giga bit and ethernet supports up to 1 meg a bit
Step 3: Display the routing table on R1.
a. What command displays the content of the routing table?
Show ip route
b. 1) How many connected routes are there (uses the C code)?
Only 1
b. 2) Which route is listed?
C 209.165.200.224/30 is directly connected
b. 3) How does a router handle a packet destined for a network that is not listed in the routing table?
The router will only send a packet to editor that is listed on the table or it will be dropped
Part 2 Step 3
a. What command did you use?
copy running-config startup-config
Part 3 Step 1
a. 1) How many interfaces on R1 and R2 are configured with IP addresses and in the “up” and “up” state?
6 interfaces
a. 2) What part of the interface configuration is NOT displayed in the command output?
No sub-net mask
a. 3) What commands can you use to verify this part of the configuration?
show running config
b. 1) How many connected routes (uses the C code) do you see on each router?
R1= 3 c codes R2= 3 c codes
b. 2) How many EIGRP routes (uses the D code) do you see on each router?
R1= 2 D codes R2= 4 D codes
b. 3) If the router knows all the routes in the network, then the number of connected routes and
dynamically learned routes (EIGRP) should equal the total number of LANs and WANs. How many LANs
and WANs are in the topology? 4 LANs & 1 WANs
b. 4) Does this number match the number of C and D routes shown in the routing table?
Yes 5=5
Ping Table:
Ping From Device IP
Ping to Device IP
Results
PC1
PC4
Connecte
d
R2
PC2
Connecte
d
