summerise

As determined in the previous section, the current time steps in the simulation do not show results for a pore volume injection value of 1 or 3. As such, to determine these values, the time steps in the simulation have been increased to determine these values. The graph corresponding to the recovery factor verses pore volume injection with an extended time period shown in Figure 6.

From the graph above, the values for the recovery factor for when PVI is equal to 1 and 3 can be interpolated from the graph. This is also shown in Figure 6. As such, this yields the following result.

Water cut is defined as the ratio of water produced versus the total liquids produced. To find the water cut in the simulation, the following keyword was used. between

--Water Cut

FWCT

/

With this keyword, the following results can be exported from the simulation for both water flooding and polymer flooding as shown in Table x. A comparison between water flooding and polymer flooding has been conducted and the corresponding graph is shown in Figure x.