opm lab report

EET 4150 LAB EXERCISE #1 Analog Systems Design

INSTRUCTIONS: Perform the 3 designs listed below. Show all design steps/calculations. Use

MultiSim to verify all designs. Hardwire the first two circuits in the lab. Compare the output

with that from MultiSim. (Use the LM741 Op-Amp with +/- 18V as DC sources.)

1. Design an inverting amplifier with a gain of 27.

2. Design a non-inverting amplifier circuit to amplify the small output voltage of a

transducer of 1

3 V peak to deliver an output voltage of 8V peak to a 3.9 k load. Assume

a signal frequency of 1 kHz.

3. Design an op amp circuit to calculate the average (positive) of three inputs.

SUBMIT: A Lab Cover Sheet (on Blackboard), a title page that includes a meaningful title given

to this lab exercise (not Lab #1) , student name, date, course name and a full formal lab report

(format on Blackboard) that includes OBJECTIVE, PROCEDURE, DATA/RESULTS, DISCUSSION and

CONCLUSION sections. Prepare this report as if you were submitting this to a client or your

employer who may not be an engineer.