urgent
rocketman
KallaxShelfAssemblysample1.docxKALLAX
( 131383 )
64x
( 8 ) ( AA-1926802-1 )
( 1000 92 121030 ) ( 1x ) ( 1x ) ( 9 )
( 10 ) ( AA-1926802-1 )
( 25 ) ( 11 )
( 128415 )
( 24 ) ( AA-1926802-1 )
( 25 )
On this picture, the furniture has, barrel nut bolt, and there is also the hammer that will be used to fix in the nut in the wood. They are setting the right outside panels on the wood which will bring in a shape of a shelf .one should be careful when handling the hammer and the nut to avoid.
On picture 17; here we have the right outside panels being fixed vertically to the front base rail. This is to ensure that the groups are tightly fixed on the wood.one should ensure that they are not loose, in case they may fall off and hurt someone.
being hit as you are driving the nail.
On picture 18; we have the side base rail, which will be fixed on the on the other vertical rails already created. This creates a square like a figure on the wood being created. This will give support to the different vertical tracks so that they may not fall off. In it we can see small holes where the nails will be fixed to support it together with other rails.it is being held parallel to the piece of wood to see whether it will fit perfectly as required.
On picture 19 we can see an Allen key wrench and a screw tool. The Allen key wrench has a function of tightening up the loosen screw tools or can even be used in tattoo machines. So the Allen tool will be used in tightening the screw on the piece of wood.
On picture 20 we have a hammer and a screw being fixed on the piece of wood. The crews will be used to support the right outside panel, which will make the spaces left in between, be square in shape.
On picture 21 we have the panel rail, being measured against the piece of wood, to check whether it can fit perfectly. On the wood, we have to set of holes both on the right side and the left side. On top and the bottom.
On picture 22 we have the screws being fitted into the two holes on sides of the panel, using the Allen key wrench. We can see that the screw will be fixed in an anticlockwise direction. While the clockwise direction is loosening up the bolt.
On picture 24, we can see the furniture, which looks like a shelf being lifted up from the ground. The people are lifting it, are holding it right from the base, which will prevent it from sliding from the hands as you are raising it.
On picture 25, we can see that the furniture is halfway up. The side with the shelves is being fitted, facing the front side.
( 29 )
On picture 26, we can see instructions on how to fix the screws on the topmost side shelves. We also see guidelines that one should not climb up the ledges, else you will fall with it.
On picture 27 we are being warned of the best shelf pin to use on the walls of the furniture, and not use the nails that look like shelf pins because they are not allowed (Dangelico, 2013). One should fix it in an anticlockwise direction, using a screwdriver.
On picture 28 we have the barrel nut bolt being fixed on the topmost board of the shelf, using an Allen key. On the last map 29, we can see the diameter of the hole that the nut is being fixed and the place it is being repaired, which is the first board of the shelf.
On the last map 29, we can see the diameter of the hole that the nut is being fixed and the place it is being repaired, which is the first board of the shelf.
KALLAX
KALLAX
