Architecture and Design Assignment 5

Gutter & Downspout Parts   

   

 

Rectangular downspouts and elbows are the standard downspout used with k style gutters.

Available in 2x3, 3x4, and 4x5.

Available in aluminum, copper, galvanized and lead coated copper.   Available in 10’ lengths. 

 

K Style gutters were designed originally for roofs with flat vertical edges. These roofs are commonly seen on Colonial Revival and other structures popular from the 1910's through the 1930's. The K Style gutter is shaped to be mounted against the flat fascia board, and to mimic classical crown moldings. 5" and 6" gutters can ship any length up to 20 ft. Can also be produced on site to any length.

 

An "A" style elbow refers to an elbow that, when attached to a downspout, angles the downspout frontwards and backwards. 

 

A "B" style elbow refers to an elbow that, when attached to a downspout, angles the downspout from right to left or from left to right (sideways). 

Gutter & Downspout Parts   

 

Miters, or corner pieces, are the gutter fittings that connect two gutters at a corner. 

 

A K Style gutter end cap is the fitting that attaches to and closes off the end of the gutter. This particular end cap is sometimes referred to as the Crimp On End Cap.

The crimp on end cap is the contractor standard and is the easiest and fastest to install on to the gutter. It requires the use of a hand tool called the end cap crimper. This installation does not require any fasteners.   End caps are available in left and right. 

 

K‐style pop outlet.    One needed for each downspout location. 

 

Gutter Hangers are the brackets that give the gutter its strength and support. The type of gutter bracket and its spacing will largely determine the longevity of any gutter system. Quick Screw Gutter Hangers are manufactured with the screw in place and ready to go. Designed to save time. Just get the drill out and go!   Placed 16” or 24” on center.