Assignment 9: Drawings and Specifications
lolmrsnipe
CMGT31033_DrawingsandSpecsAssignment.docxCMGT 31033-Mechanical Systems for Construction Managers.
Dr. Onsarigo Lameck.
|
Assignment 9: Drawings and Specifications |
Student Names: ________________________ |
You have been provided with a copy of plans and specifications for the proposed new Technology Service Center for a Miami Schools Project. For this assignment, you will need M-1 from your drawings and Division 15 specs.
Respond to the questions below citing where you found the answer (the first 2 are examples to STRICTLY follow as you respond to the rest). No points will be given unless you cite where the answer came from (60 Points).
|
Question |
Answer |
Citation |
|
Example 1: Are the dimensions of the rectangular ductwork the actual internal dimension, or should it actually be smaller or larger? |
Those are outside dimensions to allow ½” liner |
M-1 Notes #4 |
|
Example 2: What ASTM standard must the duct liner conform to? |
ASTM C553 |
15880-2, 2.8, C. |
|
1. What manufacturer was used for the plans for the Grilles? |
|
|
|
2. How many Btu’s of electric heat does heat pump number 2 produce? |
|
|
|
3. What type and size of air filters are required for the heat pumps and duct work? |
|
|
|
4. All heat pump units on this project should be equal to what manufacturer? |
|
|
|
5. What is the height of the main supply ductwork for unit #1? |
|
|
|
6. Can the size of the duct be quickly reduced at an angle of 70°? |
|
|
|
7. How thick should the heat pump pads be? |
|
|
|
8. How many CFM is planned for the Break room (Rm 111)? |
|
|
|
9. Do you foresee any issues with duct crossing each other in the vault Room 108, and what ducts are those? |
|
|
|
10. What voltage is Heat Pump #3? |
|
|
|
11. Which types of thermostats are required for the project |
|
|
|
12. What trade takes precedence in routing? |
|
|
|
13. Is a Crankcase heater required for the compressors on the Heat pumps? |
|
|
|
14. What is the longest length of flexible duct that can be used to connect diffusers or troffer boots to the low pressure duct? |
|
|
|
15. What is the percentage of tolerance the air outlets and inlets have to be adjusted to for air balancing? |
|
|
