ET372 Week 4

profilejav284
  1. A temperature sensor is exposed to a sudden change of 20oC to 80oC. The sensor outputs 0.02 volts for every oC of temperature and has a 2.3 second time constant.
  2. What is the sensor output voltage at 1.5 seconds?
  3. At what time, t, does the sensor output become 1.0 volt?
  4. figure 1
  5. A sensor, R, that changes resistance is used in a bridge circuit as shown below.
  6. What sensor resistance, R, will null the bridge?
  7. What is the off-null voltage if R changes by 0.5 Ω?
  8. figure 2
  9. A measurement system has noise above 20 kHz and the data signal frequency is between 100 and 500 Hz. Design an RC filter that reduces the noise by 95%, i.e., only 5% is left. Show the schematic and the component values.
  10. Given a Type J TC with a 25oC reference.
  11. What is the temperature if the TC voltage is 22.87 mV?
  12. What voltage would result from a temperature of 225oC?
  13. A 10-bit ADC has a 5.00-volt reference.
  14. What binary output is produced by an input of 3.04 volts?
  15. Suppose the output is found to be 1F4h. What is the possible input voltage?
  16. A 12 bit bipolar DAC has a 10-volt reference.
  17. If the hex input is 5D7h what is the DAC output voltage?
  18. What input is required to get a zero volt output?

 

**PLEASE SEE ATTACHMENT**

  • 8 years ago
  • 10
Answer(2)

Purchase the answer to view it

blurred-text
  • attachment
    week_4_midterm_jav.docx

Purchase the answer to view it

blurred-text
NOT RATED
  • attachment
    answer.docx