Capacitive Circuits in Multisim

Capacitive Circuits in Multisim

This week’s lab is based on the application of circuit analysis techniques to a capacitive circuit in Multisim.

1. Watch the video lecture entitled “Week 3 - Capacitor Op-Amp Circuit in Multisim.
2. Construct Figure 7.36 in Chapter 7 (Example 7.11) with Vs = 3sin200tV, R1=20kohms, Cf=5uF, and Vc(0) = 1.5 and find the output voltage ‘Vout’.
3. Interchange the positions of the capacitor and resistor and compute the output voltage ‘Vout’ and record the values in the table below.

1. Construct Figure 7.36 from Chapter 7 in Multisim.
   1. Use the function generator to provide Vs to the circuit and run simulation to measure the Vout using Oscilloscope. (Use 5% tolerances for the resistor)
   2. Interchange the positions of the resistor and capacitor and run the simulation to record the measurements of ‘Vout’ in the table above. (Use 5% tolerances for each of the resistors)
   3. Take the screen capture for the measurements for ‘Vout’.
2. Answer the following questions:
   1. Are the measured values same as calculated values? If not, explain why they are different?
   2. What type of a circuit does Figure 7.36 represent? Provide a practical use of this kind of Op Amp Circuits.
   3. When you interchange the resistor and capacitor, what type of a circuit is obtained? Provide a practical use of this kind of Op Amp Circuits.
   4. Use the results obtained from ‘Vout’ to explain the differences in these two circuits.
3. Create a new word document called “Lab3_StudentID.docx” with your GID substituted into the file name.
4. Save the analysis from step 2 & 3 and simulation results from step 4 along with the table and screen captures of all the measurements. Make sure to answer the questions in step 4.
5. Upload file “Lab3_StudentID”.

Grading Rubrics