Fluid power Lab

ET 4850 – Lab 7

Catherine Chunn

Richard Horst

Michael Wigdor

Abdulmajeed Alotaibi

Parts List

Objective

Procedure

Results

The pneumatic circuit was built according to the schematic diagram. It was built correctly the first time aside from swapping out some connections. At first, the cylinder was very slow when extending and retracting. The time delay valve and pressure regulators were adjusted to allow the cylinder to remain in the extended state for 3 seconds and in the retracted state for 2 seconds. This would only happen when the switch was closed.

Conclusions/Comments

Appendices