Optical Sensors Lab
Using Multisim, design a system using the photoconductive cell shown in the figure below to measure and display light intensity. Make the design such that 20 to 100mW/cm2 produces an output of 0.2 to 1.0V. What is the readout error when the intensity is 60mW/cm2? Show all calculations and Multisim results.
- For the turbidity system show in Figure 2 below, two matched photoconductive cells are used in R vs. IL as given in Figure 3 below. Design a signal-conditioning system that outputs the deviation of the flowing system turbidity in volts and triggers an alarm if the intensity is reduced by 10% from the nominal of 15mW/cm2.
- Figure 2
- Figure 3**PLEASE SEE ATTACHMENT**
11 years ago 10
Answer(2)
Purchase the answer to view it
- week_5.zip
Purchase the answer to view it
NOT RATED
- answer.zip
Bids(1)